User's Manual

This device has been designed to operate with
the antennas listed below, and having a
maximum gain of 3 dBi. Antennas not included in th
is list or having a gain greater than 3 dBi are
strictly prohibited for use with this devic
impedance is 50 ohms.
To reduce potential radio interf
erence to other users, the ant
enna type and its gain should be so
chosen that the equivalent
isotropically radiated power (e.i.r.p
.) is not more than that permitted
for successful communication.
Industry
Canad
Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is
subject to the following two conditions:
subject to the followi-
ng two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept
ng two conditions:(1)This device may not cause harmful interference,
any interference received, including interference that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio
exempts
ex-
empts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit
reçu
pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage
,y compris
empts de licence. Son fonctionnement est sujet aux deux conditions suivantes:(1)le dispositif ne doit
pas produire de brouillage préjudiciable, et(2)ce dispositif doit accepter tout brouillage
pas produire de brouillage préjudiciable, et.(2)ce dispositif doit accepter tout brouillage
,y comp-
ris un brouillage susceptible de provoquer un fonctionnement indésirable.
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential
Caut
:
for harmful interference to co-channel mobile satellite systems;
(ii)the maximum antenna gain permitted for devices in the bands 5250-5350MHz and 5470-5725MHz
shall comply with the e.i.r.p. limit;
(iii) the maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with
the e.i.r.p. limits specified for point-to-point and non point-to-point operation as appropriate;
(iv) Users should also be advised that high-power radars are allocated as primary users (i.e. priority
ce
users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interfe-
rence and/or damage to LE-LAN devices.
Avertissement
:
Le guide d’ utilisation des dispositifs pour ré seaux locaux doit inclure des instructions pré cises sur
les restrictions susmentionné es, notamment :
(i) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont ré servé s uniquement pour une uti
(i) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont ré servé s uniquement pour une
utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellit-
es mobiles utilisant les mêmes canaux;
(ii) le gain maximal d’antenne permis pour les dispositifs utilisant les bandes 5 250-5 350 MHz et
(ii) le gain maximal d’antenne permis pour les dispositifs utilisant les bandes 5 250-5 350 MHz et 5
470-5 725 MHz doit se conformer à la limite de p.i.r.e.;
(iv) Users should also be advised that high-power radars are allocated as primary users (i.e. priority
(v) SAR measurements are based on a 5mm spacing from the body and that compliance is achieved
at that distance
this list or having a gain greater than 3 dBi are
maximum gain of 3 dBi (Dipole antenna with 1dBi gain for 2.4GHz,Dipole antenna with 1dBi for
5GHz)Antennas not included in thn for 2.4GHz
5GHz). Antennas not included in
strictly prohibited
for use with this devic
for use with this device.
for use with this device.The required antenna
for use with this device.The required antenna impedance is 50 ohms.
a
ious
:
3