User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Quick Installation Guide
- Chapter 4 Software Configuration
- Appendix A: Specification
- Appendix B: Troubleshooting
- Appendix C: Technical Support
TD-W8151N 150Mbps Wireless N ADSL2+ Modem Router User Guide
32
seconds.
Valid lifetime: The valid lifetime for the prefix. The default value is 2592000 seconds.
RA Flags Set:
You can select ManagedAddr ,Other Config or both. If you select
ManagedAddr, you should enable DHCPv6 Server (shown in Figure 4-20).
DHCPv6:DHCPv6 is provided to assign IPv6 addresses and DNS to the computers in your
LAN. Enable this function if needed.
DHCPv6 Server: Select Enable, and then you will see the screen below (shown in
Figure 4-20). The router will work as a DHCPv6 Server.
Figure 4-20
DHCPv6 Mode: Select Auto, you will see Figure 4-20. The DHCPv6 address pool will
automatically be assigned to the clients on the network. Select Manu
al, you can
configure it automatically.
Figure 4-21
Prefix/length:
Enter an
IPv6 Address prefix, and length of the prefix.
Preferred Lifetime: The preferred lifetime for the prefix.
Valid lifetime: The valid lifetime for the prefix.
Primary DNS:
Type in your preferred DNS server.
Second DNS: Type in your secondary DNS server.
4.3.3 Wireless
Choose “Interface Setup→Wireless” menu, and you will see the Wireless screen (shown in
Figure 4-22 ). Please configure the parameters for wireless according to the
descriptions below.