Specifications
Table Of Contents
- Package Contents
- Chapter 1. Product Overview
- Chapter 2. Connecting the Modem Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuring the Modem Router
- 4.1 Login
- 4.2 Device Info
- 4.3 Quick Setup
- 4.4 Advanced Setup
- 4.5 IPTV
- 4.6 Wireless
- 4.7 Guest Network
- 4.8 Diagnostics
- 4.9 Management
- 4.10 Logout
- Appendix A: Specifications
- Appendix B: Configuring the PC
- Appendix C: Troubleshooting
TD-W8950N 150Mbps Wireless N ADSL2+ Modem Router User Guide
27
Click Restore Default button to restore the WAN Interface’s default MAC Address.
Note:
Only the WAN Ports can use MAC Address Clone function. All the clone MAC addresses must not
be the same with each other.
4.4.4 LAN
4.4.4.1 IPv4 LAN Config
Choose “Advanced Setup”“LAN”, and you will see the LAN screen (shown in Figure 4-21), the
section allows you to configure the router’s LAN ports settings.
Figure 4-21
IP Address: You can configure the router’s IP Address and Subnet Mask for LAN Interface.
• IP Address: Enter the router’s local IP Address, then you can access to the Web-based
Utility via the IP Address, the default value is 192.168.1.1.
• Subnet Mask: Enter the router’s Subnet Mask, the default value is 255.255.255.0.
Enable IGMP Snooping: If you select the option, please choose the IGMP Mode: Standard
Mode or Blocking Mode.
Enable LAN side firewall: You can click the check box to enable LAN side firewall.
DHCP Server: These settings allow you to configure the router‘s Dynamic Host Configuration
Protocol (DHCP) server function. The DHCP server is enabled by default for the router’s
Ethernet LAN interface. DHCP service will supply IP settings to computers which are
configured to automatically obtain IP settings that are connected to the router though the
Ethernet port. If you enable the DHCP server, the router becomes the default gateway for