User's Manual

TD-W8961N 300Mbps Wireless N ADSL2+ Modem Router User Guide
24
 Servicename: Enter a name to mark current connection, or you can leave it blank.
 Username: Enter your username for your PPPoA/PPPoE connection.
 Password: Enter your password for your PPPoA/PPPoE connection.
 Encapsulation: For both PPPoA/PPPoE connection, you need to specify the type of
Multiplexing, either LLC or VC Mux.
 Bridge Interface: Activate the option, and the modem router can also work in Bridge mode.
 Connection: For PPPoA/PPPoE connection, you can select Always on or Connect
on-Demand or Connect Manually. Connect on demand is dependent on the traffic. If there
is no traffic (or Idle) for a pre-specified period of time), the connection will tear down
automatically. And once there is traffic send or receive, the connection will be automatically
on.
 Default Route: You should select Yes to configure the PVC as the default gateway to
internet from this device.
 Get IP Address: Select Static or Dynamic. For PPPoA/PPPoE connection, you need to
specify the public IP address for this ADSL modem router. The IP address can be either
dynamically (via DHCP) or given IP address provided by your ISP. For Static IP, you need to
specify the IP address, Subnet Mask and Gateway IP address.
4) Bridge Mode