User's Manual

TD-W8961ND 300Mbps Wireless N ADSL2+ Modem Router User Guide
23
3) PPPoA/PPPoE
Select this option if your ISP requires you to use a PPPoE connection. This option is typically
used for DSL services. Select Dynamic PPPoE to obtain an IP address automatically for your
PPPoE connection. Select Static PPPoE to use a static IP address for your PPPoE connection.
Please enter the information accordingly.
 Servicename: Enter a name to mark current connection, or you can leave it blank.
 Username: Enter your username for your PPPoA/PPPoE connection.
 Password: Enter your password for your PPPoA/PPPoE connection.
 Encapsulation: For both PPPoA/PPPoE connection, you need to specify the type of
Multiplexing, either LLC or VC Mux.
 Bridge Interface: Activate the option, and the modem router can also work in Bridge mode.
 Connection: For PPPoA/PPPoE connection, you can select Always on or Connect
on-Demand or Connect Manually. Connect on demand is dependent on the traffic. If there
is no traffic (or Idle) for a pre-specified period of time), the connection will tear down
automatically. And once there is traffic send or receive, the connection will be automatically
on.
 Default Route: You should select Yes to configure the PVC as the default gateway to
internet from this device.
 Get IP Address: Select Static or Dynamic. For PPPoA/PPPoE connection, you need to
specify the public IP address for this ADSL modem router. The IP address can be either