User's Manual

TD-W89
68 300Mbps Wireless N USB ADSL2+ Modem Router User Guide
)
Note:
To completely configure
the WAN Interface, you need to first select the Layer2 Interface (4.5.1
Laye
r2 Interface
) according to the co
nnection ISP provides for you, and then to select the type of
the connection (4.5.2
WAN Service) for the further configuration
.
4.5.1 Layer2 Interface
4.5.1.1 ATM Interface
Choose “Ad
vanced Setup”Æ“Layer2 Interface“Æ“ATM Interface”, you can Configure ATM
interfaces on the screen below.
Figure 4-
3
¾ Remove: Select the check box in the table on the screen above and then click the Remove
button, the corresponding interface will be deleted in the table.
)
Note:
If
the interface is used by the configuration of the 4.5.2
WAN Service, you need to r
emove the
corresponding WAN Service entry first before you can remove it here.
¾ Add: Click the button, and you can add a new interface in the next screen.
Figure 4-
4
¾ VPI/VCI: the VPI and VCI values provided by your ISP. Do not change them unless it was
required by your ISP.
18