User's Guide

TL-WA701ND 150Mbps Wireless Lite N Access Point User Guide
2.2 The Back Panel
Figure 2-2
¾ Wireless antenna
¾ Factory Default Reset button
There are two ways to reset the device's factory defaults:
• Use the Factory Defaults function on “System Tools → Factory Defaults” page in the
AP's Web-based Utility.
• Use the Factory Default Reset button: With the AP powered on, use a pin to press and
hold the Reset button (about 5 seconds) until the System LED becomes quick-flash from
slow-flash. And then release the button and wait the AP to reboot to its factory default
settings.
)
Note:
Ensure the device is powered on before it restarts completely.
¾ One LAN 10/100Mbps RJ45 port for connecting the device to hub or switch.
¾ Power socket: only use the power adapter supplied with the TL-WA701ND 150Mbps Wireless
Lite N Access Point, use of a different adapter may result in product damage.
2.3 System Requirements
¾ TCP/IP protocol must be installed on each PC
¾ Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator 6.0 or later
¾ 802.11n, 802.11g or 802.11b-compliant devices, such as the TL-WN721N Wireless Adapter
4