User's Manual
Table Of Contents
- EN 301 489-1 V1.9.2 & EN 301 489-17 V2.2.1
- Yang Hongliang
- CONTENTS
- Package Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Quick Installation Guide
- Chapter 4 Configure the Device
- Appendix A: Application Example
- Appendix B: Factory Defaults
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
TL-WA801ND 300Mbps Wireless N Access Point User Guide
18
System Up Time - This filed displays the run time of the AP since it’s powered on or reset.
Note:
If you select Client mode in Figure 4-25, the wireless status in Figure 4-3 will change, similar to the
figure below:
Figure 4-4 Device Status - Client
4.3
Quick Setup
Please refer to Section 3.1 Quick Setup for more details.
4.4
WPS
WPS (Wi-Fi Protected Setup) can help you to quickly and securely connect to a network. This
section will guide you to add a new wireless device to an existing network quickly by function. The
WPS function is only available when the Operation Mode is set to Access Point and Multi-SSID.
Here we take the Access Point mode for example. Select menu “WPS”, you will see the next
screen shown in Figure 4-5.
Figure 4-5 WPS
WPS Status - To enable or disable the WPS function here.