User's Manual

TL-WA801ND 300Mbps Wireless N Access Point User Guide
71
5) Select Use the following IP address, enter the 192.168.0.100 into the IP address field,
255.255.255.0 into the Subnet mask field.
Now, try to log on to the Web-based configuration page again after the above settings have
been configured. If you still cannot access the configuration page, please restore your Access
Point’s factory default settings and reconfigure your Access Point following the instructions of
this UG. Please feel free to contact our Technical Support if the problem persists.

Note:
While the reconfiguration is done, you need to change the IP address settings as below. Then,
with the correct hardware connection, you can surf the Internet successfully.