User's Guide

31
Chapter 4
Congure the Access Point
• If you do not set the key, the wireless security function is still disabled even if you have selected Shared
Key as Authentication Type.
• You will be reminded to reboot the device after clicking the Save button.
Repeater/Bridge
You can choose which SSID to configure wireless security settings for in the blank
behind Operation Mode.
• Disable Security - Check this box radio button to disable wireless security. If disabled,
the wireless stations will be able to connect this device without encryption. It is
strongly recommended that you choose one of the security types to enable security.
• WPA/WPA2-Personal (Recommended) - Select WPA/WPA2 based on Radius Server.
• Version - You can select one of following versions.
• Automatic (Recommended) - Select WPA-Personal or WPA2-Personal automatically based on
the wireless station’s capability and request.
• WPA-PSK - Pre-shared key of WPA.
• WPA2-PSK - Pre-shared key of WPA2.
• Encryption - You can select either Automatic(Recommended), TKIP or AES.
• Wireless password - You can enter ASCII or Hexadecimal characters. For
Hexadecimal, the length should be between 8 and 64 characters; for ASCII, the
length should be between 8 and 63 characters.
• Group Key Update Period - Specify the group key update interval in seconds.
The value can be either 0 or at least 30. Enter 0 to disable the update.
• WPA/WPA2-Enterprise - Select WPA/WPA2 based on Radius Server.
• Version - You can select one of following versions.
• Automatic - Select WPA or WPA2 automatically based on the wireless station’s capability and
request.
• WPA - Wi-Fi Protected Access.
• WPA2 - WPA version 2.
• Encryption - You can select either Automatic, TKIP or AES.
• Radius Server IP - Enter the IP address of the Radius Server.
• Radius Port - Enter the port used by radius service.
• Radius password - Enter the password for the Radius Server.