User's Manual

TL-WA830RE 300Mbps Wireless N Range Extender User Guide
12
¾ Firmware Version - This field displays the current firmware version of the Range Extender.
¾ Hardware Version - This field displays the current hardware version of the Range Extender.
¾ Connection Status to Existing Network - This part shows you the current information of the
root wireless network which the device is connecting to.
z Root Wireless Network Name (SSID) - It shows the name of the wireless network which
your device is connecting to.
z Signal - It shows the root wireless network's signal strength that the device has received.
z Connection Status - It shows whether your device has been connected to a wireless
network currently. "Connected" means the range extender have connected to a wireless
network, while if it shows "disconnected", you can click "connect" to connect.
¾ Wired - This field displays the current settings or information for the Network.
z MAC Address - The physical address of the system, as seen from the Network -> LAN
page.
z IP Address - The IP address of the wired LAN.
z Subnet Mask - The subnet mask associated with IP address.
¾ Wireless - This field displays basic information or status for wireless function.
z Operation Mode - Indicates the mode which the device is working on. "Disable" means
the wireless radio has been turned off. You can configure it in the Wireless -> Wireless
Settings page.
z Local Wireless Network Name (SSID) - The Device's wireless network name (also
called SSID) which your PC or other device can be connected to.
z Channel - The current wireless channel in use.
z Mode - The current wireless mode which the Range Extender works on.
z Channel Width - The bandwidth of the wireless channel.
z Wireless Rate - It shows the current wireless rate between the range extender and your
PC or other devices which are connected to the it.
¾ Traffic Statistics - This field displays the Range Extender's traffic statistics.
z Sent (Bytes) - Traffic that counted in bytes has been sent out from wireless.
z Sent (Packets) - Traffic that counted in packets has been sent out from wireless.
z Received (Bytes) - Traffic that counted in bytes has been received from wireless.
z Received (Packets) - Traffic that counted in packets has been received from wireless.
¾ System Up Time - This filed displays the run time of the Range Extender since it’s powered
on or reset.
¾ Click the Refresh button to get the latest status and settings of the device.
)
)
Note:
If you select Access Point mode in Figure 3-10, the wireless status in Figure 4-1 will change,
similar to the figure below: