User's Manual

TL-WA830RE 300Mbps Wireless N Range Extender User Guide
20
1) Access Point: This mode allows wireless stations to access this device.
Figure 4-10 Wireless Settings in Access Point mode
¾ Operation Mode - Three Operation Modes are supported, including: Access Point, Range
Extender mode 2, Range Extender mode 1.
¾ SSID (Set Service Identifier) - Identifies your wireless network name. Create a name up to 32
characters and make sure all wireless points in the wireless network with the same SSID. The
default SSID is TP-LINK_Extender_XXXXXX (XXXXXX indicates the last unique six
characters of each device’s MAC address). This value is case-sensitive. For example, TEST
is NOT the same as test.
¾ Region - Specifies the region where the wireless function of the Range Extender can be
used. Select your region from the drop-down list. If your country or region is not listed, please
contact your local government agency for assistance.
)
)
Note:
The default region is United Kingdom. When you select your local region from the pull-down
list, the dialog shown in Figure appears below. Click OK.
¾ Channel - Determines the operating frequency to be used. It is not necessary to change the
wireless channel unless you notice interference problems with another nearby access point.
¾ Mode - Select the desired wireless mode. The options are:
x 11b only - Only 802.11b wireless stations can connect to the device.
x 11g only - Only 802.11g wireless stations can connect to the device.
x 11n only - Only 802.11n wireless stations can connect to the device.