User's Manual

TL-WA830RE 300Mbps Wireless N Range Extender User Guide
21
x 11bg mixed - Both 802.11b and 802.11g wireless stations can connect to the device.
x 11bgn mixed - All 802.11b, 802.11g and 802.11n wireless stations can connect to the
device.
¾ Channel Width - Determines the channel width to be used. It is unnecessary to change the
default value unless required.
¾ Max Wireless Rate - You can limit the maximum wireless rate of the device through this field.
¾ Enable Wireless Radio - Select or deselect this check box to allow or deny wireless stations
to access the device.
¾ Enable SSID Broadcast - Select or deselect this check box to allow or deny the device to
broadcast its name (SSID) on the air. If it’s allowed, when wireless clients survey the local
area for wireless networks to associate with, they will detect the SSID broadcast by the
device.
)
)
Note:
To apply any settings you have altered on the page, please click the Save button, and then you
will be reminded to reboot the device.
2) Range Extender mode 2: In this mode, the Range Extender with WDS enabled will relay
data to an associated root Range Extender. Range Extender function is enabled meanwhile.
The wireless repeater relays signal between its stations and the root AP for greater wireless
range. Please input the MAC address of root AP in the field "MAC Address of Root AP".
Figure 4-11 Wireless Settings in Range Extender mode 2
¾ Operation Mode - Three Operation Modes are supported, including: Access Point, Range
Extender mode 2 and Range Extender mode 1.
¾ Survey - Click this button, you can search the AP which runs in the current channel.