User's Guide
Table Of Contents
- Package Contents
- Conventions
- Overview of This Guide
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Configure the PC
- Chapter 4 Configure the Device
- Appendix A: Application Example
- Appendix B: Factory Defaults
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
TL-WA901ND 300Mbps Wireless N Access Point User Guide
Method Three:
Step 1: Keep the default QSS Status as Enabled and click the Add device button in Figure 4-4,
then the following screen will appear.
Figure 4-5 Add A New Device
Step 2: Choose “Press the button of the new device in two minutes” and click Connect.
Step 3: For the configuration of the wireless adapter, please choose “Push the button on my
access point” in the configuration utility of the QSS as below, and click Next.
The QSS Configuration Screen of Wireless Adapter
Step 4: Wait for a while until the next screen appears. Click Finish to complete the QSS
configuration.
18