User's Guide
Table Of Contents
- Package Contents
- Conventions
- Overview of This Guide
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Configure the PC
- Chapter 4 Configure the Device
- Appendix A: Application Example
- Appendix B: Factory Defaults
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
TL-WA901ND 300Mbps Wireless N Access Point User Guide
Note Dialog
)
Note:
Limited by local law regulations, version for North America does not have region selection
option.
¾ Channel Width - Determines the channel width to be used. It is unnecessary to change the
default value unless required.
¾ Enable Wireless Radio - Select or deselect this check box to allow or deny wireless stations
to access the device.
Click the Search button to detect the SSIDs in the local area.
)
Note:
To apply any settings you have altered on the page, please click the Save button, and then you
will be reminded to reboot the device.
4) Repeater: This mode allows the AP with its own BSS to relay data to a root AP to which it is
associated with WDS enabled. The wireless repeater relays signal between its stations and
the root AP for greater wireless range.
Figure 4-11 Wireless Settings in Repeater mode
28