User's Manual
Table Of Contents
- Package Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Quick Installation Guide
- Chapter 4 Configure the Device
- Appendix A: Application Example
- Appendix B: Factory Defaults
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
TL-WA901ND
300Mbps Wireless N Access Point User Guide
11
In Repeater(Range Extender) mode, the product can extend the coverage of another
wireless Access Point or Router. The universal repeater mode is for the wireless Access
Point or Router which does not support WDS function.
In Bridge with AP mode, the product can wirelessly connect two or more remote LANs
together.
In Client mode, the product will act as a wireless adapter to connect your wired devices
(e.g. PC, Xbox, PS3, etc. ) to a wireless network.
In Multi-SSID mode, the product can be assigned up to four SSIDs to work with your
VLAN.
5. Select the operation mode based on your need.
A. When you choose Access Point mode, the Wireless Settings page will be shown in Figure
3-6.
Figure 3-6 Wireless Setting - Access Point mode
1) Create an easy-to-remember name for your wireless network, write it into Wireless
Network Name(SSID).
2) Select Region and Channel for your device.
3) Select Most Secure (WPA/WPA2-PSK) encryption mode and enter a password below to
prevent unauthorized access to your AP.
4) Click Next, you will then come to Network Setting page for furthers configuration.
B. When you choose Repeater(Range Extender) mode, the Wireless Settings page will be
shown in Figure 3-7.