User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuring the Router
- 4.1 Login
- 4.2 Status
- 4.3 Quick Setup
- 4.4 Network
- 4.5 Dual Band Selection
- 4.6 Wireless 2.4GHz
- 4.7 Wireless 5GHz
- 4.8 DHCP
- 4.9 USB Settings
- 4.10 NAT
- 4.11 Forwarding
- 4.12 Security
- 4.13 Parental Control
- 4.14 Access Control
- 4.15 Advanced Routing
- 4.16 Bandwidth Control
- 4.17 IP & MAC Binding Setting
- 4.18 Dynamic DNS
- 4.19 System Tools
- Appendix A: FAQ
- Appendix B: Configuring the PCs
- Appendix C: Specifications
- Appendix D: Glossary
TL-WDR3600 N600 Wireless Dual Band Gigabit Router
- 13 -
address of the router and will not offer the Internet connection any more. Therefore, it is
necessary to clone the MAC address of the computer to the router.
Figure 3-8 Quick Setup – MAC Clone
¾ If you are visiting the Router from the main computer, please select Yes, and then click
Next.
¾ If you are visiting the Router from another computer rather than the main computer,
please select No, and then click Next.
)
Note:
1) It’s strongly recommended that you visit and configure the Router from the main
computer.
2) To find the main computer’s MAC, please go to Start > Run on your main computer, type
in cmd and press Enter. At the command prompt, enter ipconfig/all and press Enter.
The MAC will be displayed as Physical Address, shown in Figure 3-9.
Figure 3-9 Find MAC Address