User's Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Installation
- Chapter 3. Print Server Installation
- Chapter 4. Software Installation
- Chapter 5. Configuration from Embedded Web Server
- Chapter 6. TCP/IP LPR Port Printing Installation
- Chapter 7. Upgrading Print Server
- Chapter 8. Troubleshooting
- Appendix A: Reset Button
- Appendix B: Frequently Asked Questions
- Appendix C: Additional Installation Instructions
36
6.3 Redhat Linux 9/Fedora Core
The Print Server can work under any Linux-based systems, including Slackware, RedHat, etc, without any
problems.
Basically, the Linux's printing system is based on BSD system. Although many commercial Linux systems are
available in the market and their commands will vary slightly, depending upon which version is used, the
functionality of the Linux-based variants is exactly the same.
Following are the outlined procedures (recommended for all users) on Red Hat Linux or later with X-Window
system installed.
1) Make sure that the TCP/IP is well configured on your RedHat system, including network interface card's
driver and IP-related settings say, IP address, subnet mask, and gateway IP).
2) Log in root.
3) Start X-windows by typing startx at the shell mode.
4) Open Printer Configuration.