User Manual
Table Of Contents
- Package Contents
- Introduction
- Connecting the Router
- Quick Installation Guide
- Basic
- Configuring the Router
- Appendix A: FAQ
- Appendix B: Configuring the PCs
- Appendix C: Specifications
- Appendix D: Glossary
-124-
TL-WR1043ND
450Mbps Wireless N Gigabit Router
2. How do I configure the router to access Internet by Ethernet users?
1) Login to the router, Choose menu “Advanced→Network→WAN”. On the WAN page,
select “Dynamic IP” for "WAN Connection Type", finish by clicking “Save”.
2) Some ISPs require that you register the MAC Address of your adapter, which is
connected to your cable/DSL Modem during installation. If your ISP requires MAC
register, login to the router and Choose menu “Advanced→ Network→ WAC Clone”.
On the "MAC Clone" page, if your PC’s MAC address is proper MAC address, click the
"Clone MAC Address" button and your PC’s MAC address will fill in the "WAN MAC
Address" field. Or else, type the MAC Address into the "WAN MAC Address" field. The
format for the MAC Address is XX-XX-XX-XX-XX-XX. Then click the "Save" button. It
will take effect after rebooting.
Figure A-3 MAC Clone
3. I want to use Netmeeting, what do I need to do?
1) If you start Netmeeting as a host, you don’t need to do anything with the router.
2) If you start as a response, you need to configure Virtual Server or DMZ Host and make
sure the H323 ALG is enabled.
3) How to configure Virtual Server: Log in to the router, Choose menu “Advanced →
Forwarding → Virtual Servers”. On the "Virtual Servers" page, click Add New….
Then on the “Add or Modify a Virtual Server Entry” page, enter “1720” for the
“Service Port” blank, and your IP address for the “IP Address” blank, taking
192.168.0.169 for an example, remember to Enable and Save.