User Manual

-10-
TL-WR1043ND
450Mbps Wireless N Gigabit Router
Chapter 2. Connecting the Router
2.1 System Requirements

Broadband Internet Access Service (DSL/Cable/Ethernet)
 One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the router is
connected directly to the Ethernet.)

PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors

TCP/IP protocol on each PC
 Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari
2.2 Installation Environment Requirements

Place the router in a well-ventilated place far from any heater or heating vent
 Avoid direct irradiation of any strong light (such as sunlight)

Keep at least 2 inches (5 cm) of clear space around the router

Operating Temperature: 0
℃
~40
℃
(32
℉
~104
℉
)
 Operating Humidity: 10%~90%RH, Non-condensing
2.3 Connecting the router
Before installing the router, make sure your PC is connected to the Internet through the
broadband service successfully. If there is any problem, please contact your ISP. After that,
please install the router according to the following steps. Don't forget to pull out the power plug
and keep your hands dry.