User Manual
Table Of Contents
- Package Contents
- Introduction
- Connecting the Router
- Quick Installation Guide
- Basic
- Configuring the Router
- Appendix A: FAQ
- Appendix B: Configuring the PCs
- Appendix C: Specifications
- Appendix D: Glossary
-15-
TL-WR1043ND
450Mbps Wireless N Gigabit Router
If you select Auto-Detect, the router will automatically detect the connection type your ISP
provides. Make sure the cable is securely plugged into the Internet port before detection.
The appropriate configuration page will be displayed when an active Internet service is
successfully detected by the router.
If the connection type detected is Dynamic IP, the next screen will appear as shown in
Figure 3- 6. Please select to clone the MAC address or not, according to your situation.
Figure 3- 6 Quick Setup – MAC Clone
If the connection type is Static IP, the next screen will appear as shown in Figure 3- 7.
Configure the following parameters and then click Next to continue.
Figure 3- 7 Quick Setup - Static IP
IP Address - This is the WAN IP address as seen by external users on the Internet
(including your ISP). Your ISP will provide you with the IP address you need to enter
here. Enter the IP address into the field.
Subnet Mask - The Subnet Mask is used for the WAN IP address. Your ISP will
provide you with the subnet mask which is usually 255.255.255.0.