User Manual
Table Of Contents
- Package Contents
- Introduction
- Connecting the Router
- Quick Installation Guide
- Basic
- Configuring the Router
- Appendix A: FAQ
- Appendix B: Configuring the PCs
- Appendix C: Specifications
- Appendix D: Glossary
-37-
TL-WR1043ND
450Mbps Wireless N Gigabit Router
5.3.4 IPTV
Choose menu “Advanced → Network → IPTV”, and you can configure the parameters of the
IPTV on the screen as below.
Figure 5- 11 IPTV
IGMP Proxy- If you want to watch TV through IGMP, please Enable it.
MODE
Automatic - There would be no change to the LAN ports, work with IGMP Proxy
technology, allowing watch IPTV via wired and wireless connection.
Bridge - Assign an individual LAN port for IPTV set-top-box, which can get IP address from
ISP directly, without any quality loss even when PCs connect with router are downloading
torrents at maximum speed, since this LAN port is isolated from other NAT LAN ports.
Port for TPTV: You can choose the Bridge LAN port from the drop list.
LAN4/ LAN3&LAN4 - The port number of LAN which will be set bridge with WAN port.
Note:
If you change the LAN port Bridge with WAN. The system will reboot, Click the Save button
to save your settings.
802.1Q Tag VLAN - ISP would provide the networking service based on 802.1Q Tag VLAN
technology. You can assign different VLAN Tag ID for different LAN ports, to connect PC,
IPTV set-top-box or IP-phone. Please contact with you ISP to get the VLAN ID information.