User Manual

-52-
TL-WR1043ND
450Mbps Wireless N Gigabit Router

Egress Bandwidth For Guest Network - The upload speed through the WAN port for
Guest Network.
 Ingress Bandwidth For Guest Network - The download speed through the WAN port for
Guest Network.

Enable Guest Network (2.4GHz) – If enabled, the Guest Network function will take effect.
 Network Name - Enter a value of up to 32 characters. The same Name (SSID) must be
assigned to all wireless devices in your Guest Network.
 Wireless Security - You can choose the security type of Guest Network here.

Version - You can choose the version of the WPA/WPA2-Personal security on the
drop-down list. The default setting is WPA2-PSK.

Encryption - You can select Automatic (Recommended), TKIP or AES as Encryption.
The default setting is AES.

Note:
If you choose TKIP encryption, you will find a notice in red as shown below.

Wireless Password - You can enter ASCII characters between 8 and 63 characters or 8 to
64 Hexadecimal characters.
 Group Key Update Period - Specify the group key update interval in seconds. The value
should be 30 or above. Enter 0 to disable the update.

Access Time - During this time the wireless stations could accessing the AP.

Note:
The range of bandwidth for Guest Network is calculated according to the setting of Bandwidth
Control on the page “Bandwidth Control->Control Settings”.
5.5.2 Storage Sharing
You can configure Guest Network Storage Sharing on this page.