User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for AP Mode
- Chapter 5. Configuration for Router Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Bridge Mode
- Chapter 8. Configuration for Client Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR700N 150Mbps Wireless N Mini Pocket Router
- 4 -
1.4 Panel Layout
Figure 1-1 TL-WR700N sketch
¾
LED
Status Indication
On The system is working properly.
Flashing The LAN/WAN cable is connected.
Off
The system is working improperly, please check the
device connection.
Table 1-1 The LED Description
¾ LAN/WAN: This LAN/WAN port works as LAN in AP/Repeater/ Bridge/Client mode and as
WAN in Router mode. As LAN, it connects the Router to the local PC; as WAN, it enables
you connect the DSL/cable Modem, or Ethernet.
¾ RESET：It is used to reset the Router to its factory defaults. With the Router powered on,
use a pin to press and hold the RESET button (about 5 seconds) until the SYS LED
becomes quick-flash from slow-flash. And then release the button and wait the Router to
reboot to its factory default settings.
¾ Power Plug: Plug in standard electrical wall socket directly to power the Router.