User's Manual

TL-WR740N/TL-WR741ND
150Mbps Wireless N Router
1.4.2 The Rear Panel
Figure 1-2 Rear Panel sketch
The following parts are located on the rear panel (View from left to right).
 POWER: The Power socket is where you will connect the power adapter. Please use the
power adapter provided with this TL-WR740N/TL-WR741ND 150Mbps Wireless N
Router.
 WAN: This WAN port is where you will connect the DSL/cable Modem, or Ethernet.
 1/2/3/4(LAN): These ports connect the Router to the local PC(s).
 WPS/Wi-Fi:
Press this button for less than 2 seconds to enable the WPS function. If your client devices,
such as wireless adapters, that support Wi-Fi Protected Setup, then you can press this button
to quickly establish a connection between the router and client devices and automatically
configure wireless security for your wireless network.
Press this button for 2 seconds to turn on or turn off the Wi-Fi. With the router powered on,
press and hold the WPS/Wi-Fi button (approximately 2 seconds) until the WLAN LED turns
on or off.
There are two ways to reset to the Router's factory defaults:
1) Use the Factory Defaults function on System Tools -> Factory Defaults page in the
Router's Web-based Utility.
2) Use the Factory Default Reset button: Press the WPS/RESET button for more than 5
seconds and then wait for the Router to reboot.
 Reset:
Press this button for more than 5 seconds to enable the Reset function. With the router
powered on, use a pin to press and hold the Reset button (approximately 8 seconds). And
then release the button and wait the router to reboot to its factory default settings.
 Wireless antenna: To r eceive and transmit the wireless data.
5