User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for WISP Client Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR80
2N
300
Mbps Wireless N Nano Router
N
ote:
1. The WPS LED on the AP will light green for five minutes if the device has been successfully
added to the network.
2. The WPS function cannot be configured if the Wireless function of the AP is disabled. Please
make sure the Wireless function is enabled before configuring the WPS.
5
.5 Working Mode
T
he Router supports five operation mode types: Wireless Router, Access Point, Repeater,
Client and Wireless Client Router. Please select one you want. Click Save to save your choice,
which is shown as Figure 5-7.
F
igure 5-7 Wireless Working Mode Settings
S
tandard Wireless Router - The wireless Router Mode. In this mode, the device enables
multi-user to share Internet via DSL/Cable Modem. The only wired port works as WAN.
Access Point - The wireless access point mode.
R
epeater - The wireless Repeater Mode. It could extend the range of wireless network.
Client - The Client Mode. The computer connected by Ethernet could get access to an AP by
Client mode.
W
ISP Client Router - In this mode, the device enables multiple users to share Internet
connection from WISP.
5
.6 Network
F
igure 5-8 the Network menu
T
here is only one submenu under the Network menu (shown in Figure 5-8): LAN.
- 107 -