User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for WISP Client Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR80
2N
300
Mbps Wireless N Nano Router
5.6.1 LAN
C
hoose menu “Network → LAN”, and then you can configure the IP parameters of the LAN on
the screen as below.
F
igure 5-9 LAN
M
AC Address - The physical address of the LAN ports, as seen from the LAN. The value
cannot be changed.
T
ype - Choosing Smart IP (DHCP) to get IP address from DHCP server, or choosing static IP
to config IP address manually.
I
P Address - Enter the IP address of your system in dotted-decimal notation (factory default -
192.168.0.254).
Subnet Mask - An address code that determines the size of the network. Normally
255.255.255.0 is used as the subnet mask.
N
ote:
1. If you change the IP Address of LAN, you must use the new IP Address to login to the Router.
2. If the new LAN IP Address you set is not in the same subnet with the previous one, the IP
Address pool in the DHCP server will be configured automatically，while the Virtual Server and
DMZ Host will not take effect until they are re-configured.
3. When you choose the Smart IP(DHCP) mode, the DHCP Server function will be disabled.
- 108 -