User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for WISP Client Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR80
2N
300
Mbps Wireless N Nano Router
c
onfigure the corresponding function. The detailed explanations for each submenu are provided
below.
5.9.1 SNMP
Cho
ose menu “System Tools → SNMP”, and then you can get the SNMP settings in the
following screen.
F
igure 5-26 SNMP Settings
SNMP Agent - Choose Enable to open this function if you want to have remote control
through SNMPv1/v2 agent with MIB-II. Choose Disable to close this function.
SysContact - The textual identification of the contact person for this managed node.
SysName - An administratively-assigned name for this managed node.
SysLocation - The physical location of this node.
Get Community - Enter the community name that allows Read-Only access to this device's
SNMP information. The community name can be considered a group password. The default
setting is public.
Get Source - Get source defines the IP address or subnet for management systems that can
read information from this 'get' community device.
Set Community - Enter the community name that allows Read/Write access to this device's
SNMP information. The community name can be considered a group password. The default
setting is private.
Set Source - Set source defines the IP address or subnet for management systems that can
control this 'set' community device.
Click the Save button to save your settings.
- 122 -