User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for WISP Client Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR80
2N
300
Mbps Wireless N Nano Router
2. T
he WPS function cannot be configured if the Wireless function of the AP is disabled. Please
make sure the Wireless function is enabled before configuring the WPS.
7
.5 Working Mode
The Router supports five operation mode types: Standard Wireless Router, Access Point,
Repeater, Client and WISP Client Router. Please select one you want. Click Save to save your
choice, which is shown as Figure 7-7.
F
igure 7-7 Working Mode
S
tandard Wireless Router - The wireless Router Mode. In this mode, the device enables
multi-user to share Internet via DSL/Cable Modem. The only wired port works as WAN.
A
ccess Point - The wireless access point mode.
R
epeater - The wireless Repeater Mode. It could extend the range of wireless network.
C
lient - The Client Mode. The computer connected by Ethernet could get access to an AP by
Client mode.
W
ISP Client Router - In this mode, the device enables multiple users to share Internet
connection from WISP.
7
.6 Network
F
igure 7-8 the Network menu
T
here is only one submenu under the Network menu (shown in Figure 7-8): LAN.
- 167 -