User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for WISP Client Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR80
2N
300
Mbps Wireless N Nano Router
7
.7 Wireless
F
igure 7-10 Wireless menu
T
here are six submenus under the Wireless menu (shown in Figure 7-10): Wireless Settings,
Wireless Security, MAC Filtering, Wireless Advanced, Wireless Statistics and Throughput
Monitor. Click any of them, and you will be able to configure the corresponding function.
7.7.1 Wireless Settings
C
hoose menu “Wireless → Wireless Settings”, and then you can configure the basic settings
for the wireless network on this page.
F
igure 7-11 Wireless Settings - Client
E
nable WDS - The AP client can connect to AP with WDS enabled or disabled. If WDS is
enabled, all traffic from wired networks will be forwarded in the format of WDS frames
consisting of four address fields. If WDS is disabled, three address frames are used. If your
AP supports WDS well, please enable this option.
W
ireless Name of Root AP - Enter the SSID of AP that you want to access.
M
AC Address of Root AP - Enter the MAC address of AP that you want to access.
- 169 -