User's Manual

TL-WR80
2N
300
Mbps Wireless N Nano Router
Ch
apter 2. Connecting the Router
2
.1 System Requirements
 Each PC in the LAN needs a working Ethernet Adapter

T
CP/IP protocol must be installed on each PC

W
eb browser, such as Microsoft Internet Explorer 5.0 or later, Mozilla Firefox, Apple Safari

I
f the device is configured to Wireless Router/Access Point mode, you also need Broadband
Internet Access Service (DSL/Cable/Ethernet)

O
ne DSL/Cable Modem that has an RJ45 connector (which is not necessary if the Router is
connected directly to the Ethernet.)
2
.2 Installation Environment Requirements

P
lace the Router in a well-ventilated place far from any heater or heating vent

P
lace the Router in a location where it can be connected to the various devices as well as to
a power source

A
void direct irradiation of any strong light (such as sunlight)

K
eep at least 2 inches (5 cm) of clear space around the Router

O
perating Temperature: 0 ℃~ 40℃ (32℉ ~ 104℉ )

O
perating Humidity: 10%~90%RH, Non-condensing
2
.3 Connecting the Router
Be
fore installing the Router, please make sure your broadband service provided by your ISP is
available. If there is any problem, please contact with your ISP. To connect the Router, please
follow the steps below:
1. Power off your PC, Cable/DSL Modem, and the Router.
2. Locate an optimum location for the Router. The best place is usually at the center of your
wireless network. The place must accord with the Installation Environment Requirements
.
3. P
lug the power plug in the electrical wall socket. The Router will start to work automatically.
After finishing the steps above, please choose the operation mode you need and carry out the
corresponding steps. There are five operation modes supported by this router: Standard
Wireless Router, Access Point, Repeater, Client and WISP Client Router.
- 5 -