User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for WISP Client Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR80
2N
300
Mbps Wireless N Nano Router
2.3.1 Standard Wireless Router Mode
As
a wireless router, TL-WR802N enables multi-user to share Internet via DSL/Cable Modem.
The default mode of TL-WR802N is Wireless Router. On this mode, the wired port LAN/WAN
works as WAN, it can be connected to DSL Modem or directly connected to a wired network with
an Ethernet cable. Computers could connect to the device by both wired way through the wired
port LAN and wireless way.
F
igure 2-1 Hardware Installation of the TL-WR802N in Router Mode
1. Connect the LAN/WAN port of TL-WR802N to the LAN Port on the DSL/Cable Modem.
2. Connect the WAN port on the DSL/Cable Modem to the wired Internet.
3. Connect TL-WR802N to the power.
4. Power on the DSL/Cable Modem, PC(s) and notebook(s).
2.3.2 Access Point Mode
A
s the supplement of wired LAN, TL-WR802N enables the wired LAN to connect to the Internet
wirelessly.
Connect TL-WR802N to the power and connect the Ethernet cable correctly, you can surf the
Internet by connecting your PC(s) to the Router wirelessly.
On this mode, the wired port LAN/WAN works as LAN. Computer could connect to the device by
either wired or wireless way. The Pre-encryption function is opened by default and the default
password is the last unique eight numbers of each Router’s MAC address.
- 6 -