User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for WISP Client Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR80
2N
300
Mbps Wireless N Nano Router
F
igure 2-2 Hardware Installation of the TL-WR802N in AP Mode
1. Connect the LAN or LAN/WAN port of TL-WR802N to the wired network port with an Ethernet
cable.
2. Connect TL-WR802N to the power.
3. Power on the PC(s) and notebook(s).
2.3.3 Repeater Mode
TL-WR80
2N is used to extend the range of wireless signal of the existing AP or wireless router.
On this mode, the wired port LAN/WAN works as LAN. Computer could connect to the device by
either wired or wireless way. The SSID of TL-WR802N should be the same as that of the device
you repeat.
F
igure 2-3 Hardware Installation of the TL-WR802N in Repeater Mode
1. Connect TL-WR802N to the power.
- 7 -