User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for WISP Client Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR80
2N
300
Mbps Wireless N Nano Router
C
urrent Status - The connected wireless station's running status, one of
STA-AUTH /
STA-ASSOC / STA-JOINED / WPA / WPA-PSK / WPA2 / WPA2-PSK / AP-UP / AP-DOWN /
D
isconnected.
R
eceived Packets - Packets received by the station.
S
ent Packets - Packets sent by the station.
C
onfigure - The button is used for loading the item to the Wireless MAC Filtering list.
•
A
llow - If the Wireless MAC Filtering function enable, allow the station to access.
•
D
eny - If the Wireless MAC Filtering function enable, deny the station to access.
You cannot change any of the values on this page. To update this page and to show the current
connected wireless stations, click on the Refresh button.
If the numbers of connected wireless stations go beyond one page, click the Next button to go to
the next page and click the Previous button to return the previous page.
N
ote:
This page will be refreshed automatically every 5 seconds.
8
.8 DHCP
F
igure 8-28 The DHCP menu
There are three submenus under the DHCP menu (shown in Figure 8-28): DHCP Settings,
DHCP Client List and Address Reservation. Click any of them, and you will be able to configure
the corresponding function.
8.8.1 DHCP Settings
C
hoose menu “DHCP → DHCP Settings”, and then you can configure the DHCP Server on the
page as shown in Figure 8-29. The Router is set up by default as a DHCP (Dynamic Host
Configuration Protocol) server, which provides the TCP/IP configuration for all the PC(s) that are
connected to the Router in the LAN.
- 219 -