User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for WISP Client Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR80
2N
300
Mbps Wireless N Nano Router
F
igure 3-5 Quick Setup - Working Mode
N
ote:
The Router supports five working modes for multi-user to access the Internet: Standard Wireless
Router, Access Point, Repeater, Client and WISP Client Router. In Wireless Router mode,
the device enables multiple users to share the Internet connection via ADSL/Cable Modem. In
Access Point mode, this device can be connected to a wired network and transform the wired
access into wireless that multiple devices can share together. In Repeater mode, the device will
relay data to an associated root AP. In Client mode, the device will act as a wireless station to
enable wired host(s) to access AP. In WISP Client Router mode, the device enables multiple
users to share Internet connection from WISP. You can configure your device quickly by the
following steps in different modes.
3.2.1 Standard Wireless Router Mode
When you choose Standard Wireless Router on Working Mode page in Figure 3-5 , take the
following steps:
1. Click Next in
F
igure 3-5
,
and then WAN Connection Type page will appear as shown in
F
igure 3-6
.
F
igure 3-6 Quick Setup - WAN Connection Type
- 14 -