User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for WISP Client Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR80
2N
300
Mbps Wireless N Nano Router
F
igure 3-23 Quick Setup – WAN Connection Type
T
he Router supports five popular ways Dynamic IP, Static IP, PPPoE/Russian PPPoE,
L2TP/Russian L2TP and PPTP/Russian PPTP, to connect to the Internet. To make sure the
connection type your ISP provides, please refer to the ISP. Make sure the cable is securely
plugged into the WAN port before detection.
Dynamic IP - Your ISP uses a DHCP service to assign your Router an IP address for
connecting to the Internet. When the Router connects to a DHCP server, or the ISP
supplies you with DHCP connection, please choose this type. If you choose this type of
connection, no configuration should be set and you can go on with the wireless
configuration in
F
igure 3-28
.
S
tatic IP - This type of connection uses a permanent, fixed (static) IP address that your
ISP assigned. In this type, you should fill in the IP address, Subnet Mask, Default
Gateway, and DNS IP address manually, which are specified by your ISP. Then click
Next and proceed to Figure 3-28.
F
igure 3-24 Quick Setup - Static IP
PPPoE/Russian PPPoE - For this connection, you will need your account name and
password from your ISP.
- 24 -