User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for WISP Client Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR80
2N
300
Mbps Wireless N Nano Router
4
.13 Advanced Routing
F
igure 4-63 The Advanced Routing Menu
T
here are two submenus under the Network menu (shown in Figure 4-63): Static Routing List
and System Routing Table. Click any of them, and you will be able to configure the
corresponding function.
4.13.1 Static Routing List
C
hoose menu “Static Routing”, and you can configure the static route in the next screen, shown
in Figure 4-64. A static route is a pre-determined path that network information must travel to
reach a specific host or network.
F
igure 4-64 Static Routing
T
o add static routing entries, follow the steps below.
1. Click Add New… shown in Figure 4-64, you will see the following screen Figure 4-65.
F
igure 4-65 Add or Modify a Static Route Entry
2. Enter the following data.
Destination Network - The Destination IP Address is the address of the network or host
that you want to assign to a static route.
- 82 -