User's Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Range Extender Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for Hotspot Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR802N
300Mbps Wireless N Nano Router
- 4 -
LED
Status
Indication
Solid
The router is connected to the root Wi-Fi network or
Internet.
Blinking
Blinking steadily: The router is disconnected from the root
Wi-Fi network or Internet.
Blinking irregularly: The router is booting or updating
firmware.
Table 1-1 The LED Description
LAN/WAN: Functions as the LAN port in Hotspot Router, Range Extender, and Access Point
mode. Functions as the WAN port in Wireless Router mode. As LAN, it connects the Router
to the local PC; as WAN, it enables you connect the DSL/cable Modem, or Ethernet.
Reset：It is used to reset the Router to its factory defaults. With the Router powered on, use a
pin to press and hold the Reset button (about 5 seconds) until the LED becomes quick-flash
from slow-flash. And then release the button and wait the Router to reboot to its factory
default settings.