User's Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Range Extender Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for Hotspot Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR802N
300Mbps Wireless N Nano Router
- 181 -
will be able to configure the corresponding function. The detailed explanations for each submenu
are provided below.
7.9.1 SNMP
Choose menu “System Tools → SNMP”, and then you can get the SNMP settings in the
following screen.
Figure 7-26 SNMP Settings
SNMP Agent - Choose Enable to open this function if you want to have remote control
through SNMPv1/v2 agent with MIB-II. Choose Disable to close this function.
SysContact - The textual identification of the contact person for this managed node.
SysName - An administratively-assigned name for this managed node.
SysLocation - The physical location of this node.
Get Community - Enter the community name that allows Read-Only access to this device's
SNMP information. The community name can be considered a group password. The default
setting is public.
Get Source - Get source defines the IP address or subnet for management systems that can
read information from this 'get' community device.
Set Community - Enter the community name that allows Read/Write access to this device's
SNMP information. The community name can be considered a group password. The default
setting is private.
Set Source - Set source defines the IP address or subnet for management systems that can
control this 'set' community device.
Click the Save button to save your settings.