User's Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Range Extender Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for Hotspot Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR802N
300Mbps Wireless N Nano Router
- 197 -
2. The WPS function cannot be configured if the Wireless function of the AP is disabled. Please
make sure the Wireless function is enabled before configuring the WPS.
8.5 Operation Mode
The Router supports five operation mode types: Wireless Router, Access Point, Range
Extender, Client and Hotsopt Router. Please select one you want. Click Save to save your
choice, which is shown as Figure 8-7.
Figure 8-7 Working Mode
8.6 Network
Figure 8-8 The Network menu
There are three submenus under the Network menu (shown in Figure 8-8): WAN, MAC Clone
and LAN. Click any of them, and you will be able to configure the corresponding function.
8.6.1 WAN
Choose menu “Network → WAN”, and then you can configure the IP parameters of the WAN on
the screen below.
1. If your ISP provides the DHCP service, please choose Dynamic IP type, and the Router will
automatically get IP parameters from your ISP. You can see the page as follow (Figure 8-9):