User's Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Range Extender Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for Hotspot Router Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR802N
300Mbps Wireless N Nano Router
- 23 -
Type - Choosing SmartDHCP to get IP address from remoter DHCP server, or
choosing static IP to config IP address manually.
IP Address - Enter the IP address of your system in dotted-decimal notation (factory
default: 192.168.0.254).
Subnet Mask - An address code that determines the size of the network. Normally
255.255.255.0 is used as the subnet mask.
3. Click the Next button in Figure 3-19. You will then see the Review setting page.
Figure 3-20 Quick Setup – Review setting
3.2.4 Range Extender Mode
When you choose Range Extender Mode on Working Mode page in Figure 3-5 , take the
following steps:
1. AP list page will appear as shown in Figure 3-21. Find the SSID of the Access Point you want
to access, and select the choose checkbox in the corresponding row. For example, the 7th
item is selected. The target network’s SSID will be automatically filled into the corresponding
box which is shown as the Figure 3-22.