User's Manual

Chapter 5

Configure the Router in Hotspot Router Mode

• ICMP-FLOOD Packets Threshold (5~3600) - The default value is 50. Enter a value

between 5 ~ 3600. When the number of the current ICMP-FLOOD packets is beyond

the set value, the router will startup the blocking function immediately.

• Enable UDP-FLOOD Filtering - Tick the checkbox to enable this function.

• UDP-FLOOD Packets Threshold (5~3600) - The default value is 500. Enter a value

between 5 ~ 3600. When the number of the current UPD-FLOOD packets is beyond

the set value, the router will startup the blocking function immediately.

• Enable TCP-SYN-FLOOD Attack Filtering -Tick the checkbox to enable or disable this

function.

• TCP-SYN-FLOOD Packets Threshold (5~3600) - The default value is 50. Enter a value

between 5 ~ 3600. When the number of the current TCP-SYN-FLOOD packets is

beyond the set value, the router will startup the blocking function immediately.

• Ignore Ping Packet From WAN Port - The default setting is disabled. If enabled, the

ping packet from the internet cannot access the router.

• Forbid Ping Packet From LAN Port - The default setting is disabled. If enabled, the

ping packet from LAN cannot access the router. This function can be used to defend

against some viruses.

3. Click Save.

4. Click Blocked DoS Host List to display the DoS host table by blocking.

5. 8. 3. Local Management

1. Visit http://tplinkwifi.net, and log in with the username and password you set for the

router.

2. Go to Security > Local Management, and you can block computers on the LAN from

accessing the router.

For example, if you want to allow PCs with specific MAC addresses to access the router’s

web management page locally from inside the network, please follow the instructions

below:

1 ) Select Only the PCs listed can browse the built-in web pages to perform

Administrator tasks.