User's Manual

TL-WR810N
300Mbps Wireless N Mini Router
- 175 -
 Enable AP Isolation - This function isolate all connected wireless stations so that wireless
stations cannot access each other through WLAN. This function will be disabled if
WDS/Bridge is enabled.

Note:
If you are not familiar with the setting items in this page, it's strongly recommended to keep the
provided default values; otherwise it may result in lower wireless network performance.
7.6.5 Wireless Statistics
Choose menu “Wireless
→
Wireless Statistics”, and then you can see the MAC Address,
Current Status, Received Packets and Sent Packets for each connected wireless station.
Figure 7-12 Wireless Statistics

MAC Address - The connected wireless station's MAC address
 Current Status - The connected wireless station's running status, one of STA-AUTH /
STA-ASSOC / STA-JOINED / WPA / WPA-PSK / WPA2 / WPA2-PSK / AP-UP / AP-DOWN /
Disconnected
 Received Packets - Packets received by the station
 Sent Packets - Packets sent by the station
 Configure - The button is used for loading the item to the Wireless MAC Filtering list.
 Allow - If the Wireless MAC Filtering function enable, allow the station to access.
 Deny - If the Wireless MAC Filtering function enable, deny the station to access.
To update this page and to show the current connected wireless stations, click on the Refresh
button.
If the numbers of connected wireless stations go beyond one page, click the Next button to go to
the next page and click the Previous button to return the previous page.

Note:
This page will be refreshed automatically every 5 seconds.