User's Manual

TL-WR841HP
300Mbps High Power Wireless N Router
-37-
only.
 Mode - Select the desired mode. The default setting is 11bgn mixed.
11n only - Select if you are using 802.11n wireless clients.
11gn mixed - Select if you are using both 802.11g and 802.11n wireless clients.
11bgn mixed - Select if you are using a mix of 802.11b, 11g, and 11n wireless clients.
Select the desired wireless mode. It is strongly recommended that you set the Mode to11bgn
mixed, and all of 802.11b, 802.11g, and 802.11n wireless stations can connect to the router.
 Channel width - Select any channel width from the pull-down list. The default setting is
automatic, which can adjust the channel width for your clients automatically.

Note:
If 11bg mixed is selected in the Mode field, the Channel Width selecting field will turn grey
and the value will become 20M, which is unable to be changed.
 Channel - This field determines which operating frequency will be used. The default channel
is set to Auto, so the AP will choose the best channel automatically. It is not necessary to
change the wireless channel unless you notice interference problems with another nearby
access point.
 Enable Wireless Router Radio - The wireless radio of this router can be enabled or disabled
to allow wireless stations access. Please use the Wi-Fi button on this device to
enable/disable radio.
 Enable SSID Broadcast - When wireless clients survey the local area for wireless networks
to associate with, they will detect the SSID broadcast by the router. If you select the Enable
SSID Broadcast checkbox, the Wireless router will broadcast its name (SSID) on the air.