User's Manual
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect to the Internet
- Log In
- Configure the Router in Standard Wireless Router
- Configure the Router in Access Point Mode
- Configure the Router in Repeater Mode
- FAQ
101
Chapter 6
Congure the Router in Repeater Mode
• Rate - The unit for the Throughput.
• Run Time - How long Throughput Monitor runs.
• Transmit - Wireless transmit rate information.
• Receive - Wireless receive rate information.
Click Start / Stop to start or stop wireless throughput monitor.
6. 5. DHCP
By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the
router acts as a DHCP server; it dynamically assigns TCP/IP parameters to client devices
from the IP Address Pool. You can change the settings of DHCP Server if necessary,
and you can reserve LAN IP addresses for specified client devices.
6. 5. 1. DHCP Settings
1. Visit http://tplinkwifi.net, and log in with the default username and password:admin.
2. Go to DHCP > DHCP Settings.
3. Specify DHCP server settings and click Save.