User's Manual

TL-WR843N
300Mbps Wireless AP/Client Router User Guide
- 5 -
1.4.2 The Rear Panel
Figure 1-2 Rear Panel sketch
The following parts are located on the rear panel (View from left to right).
 ON/OFF: The switch for the power.
 POWER: The Power socket is where you will connect the power adapter. Please use the
power adapter provided with this TL-WR843N 300Mbps Wireless AP/Client Router.
 INTERNET: This INTERNET port is where you will connect the DSL/cable Modem, or Ethernet.
 4,3,2,1 (LAN): These ports (4,3,2,1) connect the Router to the local PC(s).
 ROUTER WISP: This switch is used to select working mode.
 WPS/RESET: This button is used for both WPS and Reset function. To use the WPS function,
press it for less than five seconds; to use the RESET function, press it for more than five
seconds.
 Used as RESET button:
There are two ways to reset to the Router's factory defaults:
1) Use the Factory Defaults function on System Tools → Factory Defaults page in the
Router's Web-based Utility.
2) Use the WPS/RESET button: With the Router powered on, press and hold the
WPS/RESET button (more than 5 seconds) until the SYS LED becomes quick-flash from
slow-flash. Then release the button and wait the Router to reboot to its factory default
settings.
 Used as WPS button:
If you have client devices, such as wireless adapters, that support Wi-Fi Protected Setup,
then you can press this button to quickly establish a connection between the Router and client
devices and automatically configure wireless security for your wireless network.
 Wireless antenna: To receive and transmit the wireless data.