User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuring the Router
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
- 18 -
TL-WR843N 300Mbps Wireless AP/Client Router User Guid
The router in WISP Client Router mode supports three popular ways to connect to the Internet.
Please select the one compatible with your ISP.
a) If you choose "Dynamic IP", the router will automatically receive the IP parameters from your
ISP without needing to enter any parameters.
b) If you choose "PPPoE/Russian PPPoE", you will see this page shown in Figure 3-16.
Figure 3-16 PPPoE
User Name and Password - Enter the User Name and Password provided by your
ISP. These fields are case-sensitive.
Confirm Password - Enter again the Password provided by your ISP to ensure the
password you entered is correct.
c) If you Choose "Static IP", the Static IP settings page will appear as shown in Figure 3-17.
Figure 3-17 Static IP
Note:
The IP parameters should have been provided by your ISP.
IP Address - This is the WAN IP address as seen by external users on the Internet (including
your ISP). Enter the IP address into the field.
Subnet Mask - The Subnet Mask is used for the WAN IP address, it is usually 255.255.255.0.