User's Manual

TL-WR902AC
AC750 Wireless Travel Router
- 4 -
 LED
LED Status Indication
Power
On The router is on.
Blinking The router is initializing or being upgraded.
Internet
On The Internet is available.
Off The Internet is unavailable.
Wireless
On The wireless network is enabled.
Blinking
The router fails to connect to the host network when in
Repeater or Client Mode.
Off The wireless network is disabled.
USB
On A USB device is connected.
Off No USB device is connected.
WPS
On
The LED light stays for 5 minutes when a WPS
connection is established, then goes off.
Blinking WPS connection is in progress.
Off No WPS connection is established.
 Mode Switch: This button is used to switch the working mode of the router.
 LAN/WAN: Functions as the LAN port in Hotspot, Range Extender, and Access Point mode.
Functions as the WAN port in Wireless Router mode. As LAN, it connects the Router to the
local PC; as WAN, it enables you connect the DSL/cable Modem, or Ethernet.
 Power: It is used to connect the provided power adapter.
 Reset
：
It is used to reset the Router to its factory defaults. With the Router powered on, use a
pin to press and hold the Reset button (about 5 seconds) until the LED becomes quick-flash
from slow-flash. And then release the button and wait the Router to reboot to its factory
default settings.
 3G/4G USB: It is used to plug a 3G/4G modem.