User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Range Extender Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for Hotspot Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR902AC
AC750 Wireless Travel Router
- 7 -
Connect TL-WR902AC to the power and connect the Ethernet cable correctly, you can surf the
Internet by connecting your PC(s) to the router wirelessly.
On this mode, the wired port LAN/WAN works as LAN. The Pre-encryption function is opened by
default and the default password is the last unique eight numbers of each Router’s MAC address.
1. Switch the mode of the router on AP/Rng Ext/Client.
2. Connect the router according to the steps A to E in the diagram above.
2.3.4 Range Extender Mode
TL-WR902AC is used to extend the range of wireless signal of the existing AP or wireless router.
On this mode, the wired port LAN/WAN works as LAN. Computer could connect to the device by
either wired or wireless way.
1. Switch the mode of the router on AP/Rng Ext/Client.
2. Connect the router according to the steps A to C in the diagram above.
2.3.5 Client Mode
TL-WR902AC is used as a wireless network card to connect the wireless network signal or
wireless router.
On this mode, the wired port LAN/WAN works as LAN.