User's Manual

TL-WR902AC
AC750 Wireless Travel Router
- 9 -
Chapter 3. Quick Installation Guide
This chapter will show you how to configure the basic functions of your TL-WR902AC AC750
Wireless Travel Router using Quick Setup Wizard within minutes.
3.1 TCP/IP Configuration
The default IP addresses of the TL-WR902AC have two: 192.168.0.254 for AP mode, Range
Extender mode and Client mode, and 192.168.0.1 for Wireless Router mode and HOTSPOT
mode. And the default Subnet Mask is 255.255.255.0. These values can be changed as you
desire. In this guide, we use all the default values for description. Here we take “192.168.0.254”
as an example.
Connect the local PC to the LAN port of the Router. And then you can configure the IP address for
your PC as the following steps:
1) Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your PC. If
you need instructions as to how to do this, please refer to Appendix B: "Configuring the PC”.
2) Then the built-in DHCP server will assign IP address for the PC.
Then connect to the Router through wireless connection following the steps below:
1) Click the icon
at the bottom of your desktop. Click refresh button, and then select the
default SSID of the Router. Click Connect.